Siemens FS720 Configuration page 207

Building Technologies
Fire Safety
7. Assign the required events to the 'Causes EVAC FIRE (+DEGRADED MODE)'
and 'Causes ALERT' elements with 'Assign'. For the 'Causes ALERT' element,
this can be a fire alarm in a detection zone, for example. Alternatively, you
could also assign an input signal.
Tip: Use multiselection to highlight multiple assignable elements in the dialog
window. This saves time if you want to assign an event or an event category
from several detection zones or sections to the cause group.
Tip: You can use multiselection to mark several events for an assignable
element and assign these as causes. You can also select predefined event
groups in the left part of the dialog under 'Grouped type selection'.
8. Assign the required causes to the remaining 'Causes' elements with 'Assign',
e.g., an input signal.
9. Configure the 'Causes' elements in the 'Overview' and 'Details' tabs.
10. Configure all assigned causes within a 'Causes' element in the 'Overview' tab.
11. For every 'Causes' element, configure the required voice message in the 'Audio
sequence' tab. You will find more information on configuring voice messages in
chapter 'Configuring an audio sequence [➙ 226]'.
12. Assign one or more 'Voice sounder' elements to the 'Effects' element with
'Assign'.
13. Configure the 'Voice sounder' elements in the 'Overview' tab.
'Control' task card
12
Evac control group
207 | 412
A6V10210424_j_en_--
2018-08-29