Siemens FS720 Configuration page 262

'Operation' task card
13
Person Machine Interface (PMI)
13.2.2.1 Assigning the hardware ID to the LED
13.2.2.2 Assigning the pre-defined cause
262 | 412
Building Technologies
Fire Safety
The figure below shows the assignment of the hardware ID to the corresponding
LED on the ↑ Person Machine Interface. The numbers correspond to the hardware
ID of the LED.
3
4
5
6
Figure 86: Assigning the hardware ID to the LED
You will find the hardware ID in the detail editor of the LED in the 'HW ID LED' field.
Figure 87: Detail editor of a LED with details of the hardware ID
● You can assign the pre-defined causes to each configurable LED. You can
assign several pre-defined causes to one LED.
● If you assign several causes, the LED properties must be different from each
other, e.g., 'Priority', 'LED mode', or 'Colour'.
Assigning an LED with a pre-defined cause
1. Select the 'Operation' > ↑ 'Station' > Element with LEDs > LED task card.
2. In the toolbar, click on 'Assign'.
a The 'Assign dialog' window opens.
3. Select 'Pre-defined causes' at the left in the window and highlight 'Standard' at
the right in the window.
4. Click on 'Assign'.
a The 'Cause / Undefined' element is created under the LED.
5. Highlight the 'Cause / Undefined' element.
6. Set the properties you want in the detail editor.
7. If required, change the inscription on the LED on the device.
You will find editable inscription strips in the 'Inscription strips' document. See
chapter 'Applicable documents'.
1 2 3
4 5 6
7 8 9
0 #
*
C ok
24
25
A6V10210424_j_en_--
2018-08-29