Standards And Directives Complied With; Cpr Conformity And Firmware Version - Siemens FS20 Planning Manual
Fire detection system
Hide thumbs
Also See for FS20:
- Mounting & installation (354 pages) ,
- Commissioning, maintenance, troubleshooting (188 pages) ,
- Application manual (42 pages)
Table of Contents
Advertisement
Safety
2
Standards and directives complied with
2.3 Standards and directives complied with
2.3.1 CPR conformity and firmware version
20 | 242
Building Technologies
Fire Safety
Modules and spare parts
●
Components and spare parts must comply with the technical specifications
defined by Siemens. Only use products specified or recommended by
Siemens.
●
Only use fuses with the specified fuse characteristics.
●
Wrong battery types and improper battery changing lead to a risk of explosion.
Only use the same battery type or an equivalent battery type recommended by
Siemens.
●
Batteries must be disposed of in an environmentally friendly manner. Observe
national guidelines and regulations.
Disregard of the safety regulations
Before they are delivered, Siemens products are tested to ensure they function
correctly when used properly. Siemens disclaims all liability for damage or injuries
caused by the incorrect application of the instructions or the disregard of danger
warnings contained in the documentation. This applies in particular to the following
damage:
●
Personal injuries or damage to property caused by improper use and incorrect
application
●
Personal injuries or damage to property caused by disregarding safety
instructions in the documentation or on the product
●
Personal injury or damage to property caused by poor maintenance or lack of
maintenance
A list of the standards and directives complied with is available from your Siemens
contact.
In order to satisfy Ordinance No. 305/2011 (the Construction Products Regulation –
CPR), the firmware of a newly installed fire detection installation must be current
market package version MP6 or higher.
NOTICE
Firmware version of a newly installed fire detection installation not updated
No CPR conformity
●
Compare the firmware version of a newly installed fire detection installation
with the firmware version MP6.
●
Update the firmware if necessary.
008843_v_en_--
2015-12-15
Advertisement
Table of Contents
