Siemens FS720 Configuration page 145

Building Technologies
Fire Safety
Configuring the AVC settings for the line alarm
1. Select the 'Hardware' task card.
2. Highlight a ↑ detector line in the tree view.
3. Go to the 'Events' tab and select the category 'Collective FIRE ALARM (line
alarm) | ------General autom. Fire ALARM'.
4. Configure the AVC settings.
The settings are described in the sections above and below.
Figure 45: AVC settings for the line alarm
'Use individual AVC settings':
This setting specifies which alarming settings are used for the event:
● Checkbox deactivated: The superordinate alarming settings that are specified
in the 'Area' are used for the event.
● Checkbox activated: Individual alarming settings are used for the event. The
associated properties can be set as soon as the checkbox is activated. The
settings are described in the sections above.
– 'Alarming type 'manned'', 'Alarming type 'unmanned'' and 'Alarming type
'thermal''.
– Investigation time t2
– 'Local alarming devices 'manned'' and 'Local alarming devices 'unmanned''
– 'Global alarming devices 'manned'' and 'Global alarming devices
'unmanned''
'Detection' task card
11
'Area'
145 | 412
A6V10210424_j_en_--
2018-08-29