Configuring An Audio Sequence - Siemens FS720 Configuration
Fire detection system
Hide thumbs
Also See for FS720:
- Mounting & installation (248 pages) ,
- Commissioning, maintenance, troubleshooting (178 pages) ,
- Quick reference for components / pin assignment (130 pages)
Table of Contents
Advertisement
'Control' task card
12
Evac control group
12.4.4 Configuring an audio sequence
226 | 412
Building Technologies
Fire Safety
w A 'Phased voice evac control' element or a 'Prioritized voice evac control'
element is created within a 'Evac control group' element.
1. Under the element in question, mark the 'Causes' element whose 'Audio
sequence' you wish to configure.
2. Configure the parameters in the 'Audio sequence' tab.
You will find information on the parameters in a table below. Link [➙ 227]
3. Switch to the task card 'Operation'.
4. Mark 'Site' > 'Global system configuration' > 'Global behaviour'
5. Configure the parameters relevant to voice messages in the 'Details' tab. You
will find information about the parameters in the chapter 'System behavior
[➙ 255]'.
6. Save the configuration file with 'File' > 'Save'.
A6V10210424_j_en_--
2018-08-29
Advertisement
Table of Contents
