Siemens FS720 Configuration page 212

'Control' task card
12
Evac control group
Parameters
'Enabled'
'Activation timeout
'manned''
'Enabled'
'Activation timeout
'unmanned''
12.4.2.3 Multi-phase evacuation [GB]
212 | 412
Building Technologies
Fire Safety
'Phased voice evac control' – 'Effects' assignments – parameters in
the 'Overview' tab
The following table describes possible parameters in the 'Overview' tab for 'Effects'
assignments:
Values
On/off
Input field for time period
[hh:mm:ss]
Adjustment range: 0...100
min
Increments: 1 sec
On/off
Input field for time period
[hh:mm:ss]
Adjustment range: 0...100
min
Increments: 1 sec
See also
2 Configuring an audio sequence [➙ 226]
2 Sounders and sounder bases (sounders, sounder beacons,
voice sounders) [➙ 126]
Larger buildings with a higher number of floors require a staggered evacuation
process to prevent escape routes from being blocked. Evacuation is undertaken in
two stages:
1. 'Alert' phase: All floors are warned
2. 'Evac' phase: Evacuation of individual floors
Depending on the number of floors and the building structure, the 'Evac' phase is
broken down into several evacuation phases:
● In the first evacuation phase, the floor on which the fire is located as well as the
one above and the top floor, all basement floors, and possibly the ground floor
are evacuated.
● In subsequent evacuation phases, one upper and one lower floor are also
evacuated with a separately configured delay time. If needs be, additional
floors can be evacuated during the same phase.
Description
Activates or deactivates the 'Activation timeout
'manned'' parameter.
The parameter specifies the time that needs to
elapse in 'Manned' operation before the assigned
alarm device is automatically deactivated again.
Activates or deactivates the 'Activation timeout
'unmanned'' parameter.
The parameter specifies the time that needs to
elapse in 'Unmanned' operation before the assigned
alarm device is automatically deactivated again.
A6V10210424_j_en_--
2018-08-29