Cerberus Engineering Toolset - Siemens FS720 Configuration

3.2 Cerberus Engineering Toolset

Building Technologies
Fire Safety
When the Cerberus Engineering Toolset FX7230 is installed, the following
components are installed too:
● Firmware package FXS7211
● Cerberus-Engineering-Tool FXS7212
● Base data variant (BDV) FXS2004
● Set of help documents FXS7216
When the Cerberus-Engineering-Tool is installed, the two routes in the table
below are entered in the PC's network settings.
Network address Network mask
192.168.0.0 255.255.0.0
192.168.0.0 255.255.0.0
Table 2: Persistent routes
Installing the Cerberus engineering tool set FX7230
Installing the engineering tool set FX7230
1. Run the installation file.
a The installation routine starts and guides you through the installation.
2. Follow the instructions of the installation routine and observe the installation
paths.
Installation paths
During installation, you can change the standard installation paths offered.
You can change various paths subsequently within the software, but you must
then move the respective folder manually to the new location.
We do not recommend that you change the paths after successful installation in
the software.
The path for the log files cannot be changed afterwards.
If you install a version of the software with another major or minor version, new
standard installation paths are created. The existing installation paths are
retained.
You can also open the directory for log files as follows via the Start menu:
Start > All Programs > Siemens > F-FX7230 > [Version]
[Version] = Version of the software, e.g., EN_en_1-V1
1
See also
2 Engineering tool set: File name and version [➙ 34]
Installation
Cerberus Engineering Toolset
↑ Gateway Metric
address
192.168.200.1 10
192.168.201.1 10
> Log files
1
A6V10210424_j_en_--
3
27 | 412
2018-08-29