Table of Contents
Advertisement
7 System Configuration
Important:
The following points must be considered before commencing the configuration of a WiMag
Vehicle Detection System;
1. The WiMag system design must be completed before configuration.
2. The WiMag system configuration should be completed before installation and
based on a completed junction design. Although the system can be configured
after installation the time impact to the commissioning of the system may not be
considered viable.
3. The configuration is normally completed at the 'Field Service Depot' that has been
allocated to the installation.
4. Do not adjust any other settings other than those indicated as this may impact
system performance significantly and may mean the system is no longer
considered approved for installation.
5. Configure the equipment in the order presented below.
Hint: To configure each of the WiMag system elements, a fully operational
WiMag communications rack/WiMag Loop Detector Replacement Interface
Card could be used.
7.1 Configuring the interface Cards
Access to the standard interface card and the loop replacement interface card is via an
Ethernet connection, located on each card's front panel. For the standard communications
rack installation, a single interface card is supplied as part of the WiMag communications
rack assembly. Larger installations may require additional cards, which are supplied as
separate add-on kits. The add-on kits do include the appropriate backplane.
Part Number
667/HB/47200/100
Table 7 : Interface Card Configuration and User Guide
Version
11
Last Editor
Jeerh, Manpreet
Document
WIMAG GENERAL HANDBOOK
Name
Copyright © Siemens Mobility Limited 2012. All Rights Reserved.
Document Description
BVD Interface User Manual
Page 40 of 117
Status
Date
Doc. No.
Siemens Mobility Limited
Sopers Lane, Poole, Dorset
BH17 7ER
Issued
March 2020
667/HB/47200/000
Advertisement
Table of Contents
