Section 6
.
Figure 6-52 Save As Screen
Figure 6-52 Save As Screen
Completed
29. Confirm the "
a) on the Screen.
Figure 6-53 VEGA Adjustment Complete
Screen
Figure 6-53 VEGA Adjustment Complete Screen
This completes the Calibration Procedures.
Calibration Failure
This portion provides various possible error
responses that may occur while performing the
VEGA Unit Calibration.
Activation Failure
When VEGA Calibration Program is inactivate, the
following cases should be examined.
USB D
C
RIVER
ONFIRMATION
Ensure that the correct USB Drivers have been
installed on the PC (See "Installation Procedures"
on page 6-1). If the two (2) VEGA USB Drivers
usbser.sys
usbvega.inf
"
" and "
the PC, the Install Confirmation Dialog will appear.
•
OK
Click on the "
"
and install both USB Drivers.
Figure 6-54 USB Driver Confirmation Screen
a
Figure 6-54 USB Driver Confirmation Screen
C
E
OMMUNICATION
RROR
Ensure that the COM Port is correctly assigned and
the USB Cable is properly connected. If opening a
COM Port fails, the "communication error" Mes-
sage will appear.
P/N 960-100189R_Rev. 4 {EDP #148850}
VEGA™ Series Banknote Validator
b
a
c
" Message (Figure 6-53
a
M
ESSAGE
" are not installed on
Button (Figure 6-54 a)
M
ESSAGE
•
OK
Click on the "
"
and properly assign the COM Port.
Figure 6-55 Communication Error Screen
a
Figure 6-55 Communication Error Screen
Calibration Failure
This portion provides various possible error
responses that may occur while performing calibra-
tion of the VEGA Unit. When the error Dialogue
Message appears, select "
desired action.
S
E
M
ENSOR
RROR
ESSAGE
If the Reference Papers, the Sensors or the Motor
Speed Calibration procedure fails, the "
bration of entrance sensors failed. Try again?
Message appears. Select and click on the "
Button (
Figure 6-56
ton (
) to proceed.
Figure 6-56
b
Figure 6-56 Entrance Sensor Calibration
Error
a
Figure 6-56 Entrance Sensor Calibration Error
•
Yes
Click on the "
Start the failed calibration procedure again with the
Retrying the calibration of entrance
message "
sensor...
" in the Blue Message Field (Figure 6-57 a).
Figure 6-57 Retrying Calibration Message
Figure 6-57 Retrying Calibration Message
•
No
Click on the "
" Button
Save the calibration result with the message
Calibration of entrance sensor failed
"
the Blue Message Field (Figure 6-58 a).
Figure 6-58 Calibration Failed Message
Figure 6-58 Calibration Failed Message
Save As
The "
" Screen will appear (Figure 6-59) to
© 2016, JAPAN CASH MACHINE CO., LTD.
6 - 1 0
Calibration and Testing
Button (Figure 6-55 a)
Yes
No
" or "
" to perform
[Error] Cali-
" Dialog
Yes
No
) or the "
"
a
"
Button
a
" appearing in
a
"
But-
b