Figure 5-21 Setting An Output As Retentive; Figure 5-22 Removing The Retentive Setting; Figure 5-23 Flag List - Phoenix Contact Nanoline Series User Manual

2338_en_O
To set the output as a retentive item, from the output list screen, use the  or  key to
highlight the desired output. Press the <OK> key, and then press the <4> key to set the
output as retentive.
Figure 5-21 Setting an output as retentive
To set the output as non-retentive, from the output list screen, use the  or  key to
highlight the desired output. Press the <OK> key, and then press the <4> key to set the
output as non-retentive.
Figure 5-22 Removing the retentive setting
5.6.1.3 Flags
From the "Monitor Data Items" menu, select 2 to display all the flags available in the
Nanoline and the status of each one.
Figure 5-23 Flag List
A list of flags appears. Use the  or  key to scroll through the list.
– The first column indicates the number of each flag.
– The "r" indication means the flag is retentive (saved when power to the Nanoline is
removed).
– The "f" indication means the flag is forced to a state of ON or OFF.
– The third column indicates the current status of the flag (OFF or ON).
Operator Panel usage
73
PHOENIX CONTACT