C 3 Points Chart - Phoenix Contact Nanoline Series User Manual

Nanoline
Table C-4 Output points list
Module Hardware
ID
Base Q0
Base Q1
Base Q2
Base Q3
100
PHOENIX CONTACT
C 3 Points chart
The points chart records each configured input and output point. This can be provided to the
installer for connection information and stored in the job folder for use in maintenance and
troubleshooting. Note that the Label can be edited in nanoNavigator but is not visible when
using the Operator Panel.
The type of input or output is dependent on the base unit or expansion module installed. In
addition, different base units and expansion modules have different amounts of inputs and
outputs, so it is recommended to list which module has the physical connection.
Software Type
ID
Q-00
Q-01
Q-02
Q-03
Q-04
Q-05
Q-06
Q-07
Q-08
Q-09
Q-10
Q-11
Q-12
Q-13
Q-14
Q-15
Label Comments
2338_en_O