2338_en_O
5.4
Run mode
When power is first applied to the Nanoline, there are three possible screens that appear.
5.4.1
Project loaded and message sent
If a project resides on the Nanoline that was previously downloaded, upon power-up the
display can look like Figure 5-7.
Figure 5-7
Opening screen in Run mode
This screen is a user-defined screen, created in nanoNavigator and selected by the
programmer as the startup screen, that is sent to the Nanoline display when the application
is running.
5.4.2
Project loaded and no message sent
If there is a project residing on the Nanoline that was previously downloaded but has not
been sent to the display screen because the flowchart has not sent it yet, the display can
look like Figure 5-8.
Figure 5-8
Project running, no display, and no expansion modules
This screen shows that the project is running but the flow chart has not sent the user-defined
screen to the display.
The date and time are shown under the heading.
The I/O indicators show the I/O that is available within the Nanoline and the expansion
modules. If there was one expansion module attached, the display would look like
Figure 5-9.
Figure 5-9
Project running, no display, and one expansion module
Operator Panel usage
67
PHOENIX CONTACT