Ethernet Communication; Nlc-Com-Enet-Mb1 Communication Expansion Module; Memory Module Behavior At Start-Up - Phoenix Contact Nanoline Series User Manual

2338_en_O
Table 3-1

Memory module behavior at start-up

Base unit
No Operator Program
Panel
No program
With Operator Program
Panel (see
"Memory
module" on
No program
page 81)
1
The transfer only takes place if the base unit in memory module project matches
the physical base unit.
3.2

Ethernet communication

Connection to an Ethernet network requires the optional NLC-COM-ENET-MB1
communication expansion module. This attaches to the base unit through a D-SUB 9
connector on the side of each unit. Ethernet connection is through an RJ45 port on the front
of the module.
Figure 3-2

NLC-COM-ENET-MB1 communication expansion module

The NLC-COM-ENET-MB1 and NLC-050-100A-08I-04QRA-05A cannot be used
together and still meet CE compliance.
Memory module
Program
Project transferred from
memory module to base
1
unit .
Project transferred from
memory module to base
1
unit .
Nothing. The transfer is
controlled using the
Operator Panel.
Project transferred from
memory module to base
1
unit .
nanoLine Controller
Ethernet Modbus TCP
LNK/ACT
Module
Network
J1
Communication
No program
Project transferred from
base unit to memory
module.
Nothing.
Project transferred from
base unit to memory
module.
Nothing.
PHOENIX CONTACT
39