Table of Contents
Advertisement
Nanoline
42
PHOENIX CONTACT
Configuration: Setup - Data definition
In the "Display Definition" dialog box, enter appropriate values for the Scan Rate, Slave
Address, Point Type, Point Address and Length (see Figure 3-3).
Figure 3-3
"Display Definition" dialog box
Configuration: Connection - Connect with Modbus TCP
1.
Click the "Connection... Connect..." menu.
2.
From the "Connect Using:" drop-down menu, select "Remote Modbus TCP Server"
(see Figure 3-4).
Figure 3-4
"Connection Details" dialog box with remote Modbus parameters
3.
Enter the IP Address configured in nanoNavigator in the "IP Address" field. If the IP
Address was obtained using DHCP, use Wireshark or an equivalent IP sniffer to
determine the IP Address assigned.
4.
Enter 502 in the "Service Port" field (the default is 502).
5.
Click the "Protocol Selections" button and enter "1 ms" in the "Delay Between Polls"
field.
6.
Click the "OK" button.
2338_en_O
Advertisement
Chapters
Table of Contents
