Option Modules; Latch Release For Module Removal - Phoenix Contact Nanoline Series User Manual

Nanoline
14
PHOENIX CONTACT
5. If the base unit is to be removed, disconnect any input/output wiring.
A
Figure 2-4

Latch release for module removal

6. With all wires to the module disconnected, use a small screwdriver to pull down on the
release latch and lift the module off the mounting rail.
2.2

Option modules

Base unit option modules are installed in slots on the face of the base unit. Option modules
are specific to a slot and must not be installed in an incorrect location.
NOTE:
Placing an option module in the incorrect slot, or placing it in the slot in the incorrect
orientation (rotated), may cause damage to either the option module or base unit or both.
Do not force option modules into a slot. They will slide easily when properly aligned.
Install the Operator Panel and any option modules in the base unit before mounting the
unit.
2338_en_O