Monitor Mode; Figure 5-13 System Menu Without Application Loaded; Figure 5-14 System Menu With Application Loaded; Operator Panel - Phoenix Contact Nanoline Series User Manual

2338_en_O
5.5

Monitor mode

Monitor mode is used for troubleshooting and verifying operation of a control application. At
the top level of Monitor mode, the System menu allows selection of the various functions.
From any user screen, the System menu can be accessed by pressing the <Shift> and
<OK> keys simultaneously.
Figure 5-13 System menu without application loaded
A prompt appears for a password if the program is configured to require a password. Refer
to "Password" on page 79 for additional information.
If a project is running and Monitor mode is entered, the System menu displays status
information for the application.
Select Status
0 Monitor
1 Run/Stop - Stopped
Password - Not Set
Proj - Sprinkler Sy
4 Setup - PN 2701027
Figure 5-14 System menu with application loaded
Status is displayed indicating if the project is stopped or running, if a password is active, the
name of the project, system information, and if a memory module is present.
The password, project name and setup information are entered in nanoNavigator by the
programmer.
The status for each item is displayed in reverse text (light on dark) next to the associated
item.
Operator Panel usage
69
PHOENIX CONTACT