Run/Stop Menu; Figure 5-36 Stopping Program Execution; Figure 5-37 Press 1 To Start Program Execution - Phoenix Contact Nanoline Series User Manual

Nanoline
78
PHOENIX CONTACT
5.6.2

Run/Stop menu

Normally, a control program begins operating as soon as power is applied to the Nanoline
or a program is transferred from nanoNavigator or a memory module. Controlling execution
of the program can be accomplished using the Operator Panel.
WARNING:
Ensure all personnel in the operating area are clear of any machinery controlled by the
Nanoline before starting and stopping program execution.
5.6.2.1 Stopping execution
From the System menu, press the <1> key to stop the control program from executing the
program. From the screen that appears, press the <0> key to stop execution. The program
will stop running and all flow charts will be turned off.
Figure 5-36 Stopping program execution
If choosing not to stop the program, press the <Shift> and  keys to return to the System
menu.
5.6.2.2 Starting the program
From the System menu, press the <1> key. The control program will immediately begin
executing commands from the operating block at which it was stopped.
WARNING:
Execution begins immediately. Unlike stopping execution, no additional screens are
provided.
Select Status
0 Monitor
1 Run/Stop - Stopped
Password - Not Set
Proj - Sprinkler Sy
4 Setup - PN 2701027
Figure 5-37 Press 1 to start program execution
2338_en_O