Nanonavigator 2 "Nanoline Configuration" Dialog Box Showing Configuration Of Nlc-050 - Phoenix Contact Nanoline Series User Manual

2338_en_O
• Click the "Nanoline... Stop Nanoline!" menu to stop processing.
• Click the "Nanoline... Disconnect" menu to release the connection to the Nanoline.
The physical location of each input (where the wires are connected) must be verified to
ensure the physical input is associated with the correct software address. If channels are
not available, check the project configuration in nanoNavigator to ensure proper base unit
and expansion module selections (see Figure 4-2).
• Click the "Nanoline... Configuration" menu to open the "nanoLC Configuration" dialog
box.
Figure 4-1 nanoNavigator 2 "Nanoline Configuration" dialog box showing
configuration of NLC-050... system
Commissioning
57
PHOENIX CONTACT