Commissioning The Emergency Lights (Standard) - Huawei FusionModule1000B V100R003C00 Commissioning Manual

Water-cooled it solution
Table of Contents

Advertisement

FusionModule1000B Water-Cooled IT Solution
Commissioning Guide
2.
3.
4.
Step 5 Start or stop the fire alarm sounder.
When the keypad is unlocked, press ALARM BELL to start or stop the fire alarm sounder.
After the fire alarm sounder is started, the indicator beside the button turns on.
Step 6 Start or stop the fire alarm horn/strobe.
When the keypad is unlocked, press HORN/STROBE to start or stop the fire alarm
horn/strobe. After the alarm is started, the indicator beside the button turns on.
----End

9.4.2 Commissioning the Emergency Lights (standard)

Prerequisites
The sockets of the emergency light have been powered on.
Preparations
Tools: step ladder, needle-shaped tool
Documents required: power supply and distribution system diagrams, fire extinguishing
device layout diagram (standard)
Skill requirement: fire engineer
Procedure
Step 1 When you press down the TEST button on the emergency light, the emergency light turns on.
When you release the TEST button, the emergency light turns off.
Step 2 When you unplug the power plug of the emergency light, the emergency light turns on. When
you stab the small hole shown in the figure with a needle-shaped tool, the emergency light
turns off.
Issue 02 (2017-01-10)
Press S12 again to display month and date in the format of ? ? ? ?. Press S11 to adjust
the month, which changes cyclically between 1 and 12. Then press S10 to adjust the date,
which changes cyclically between 1 and 31.
Press S12 again to display hour and minute in the format of ? ?:? ?. Press S11 to adjust
the hour, which ranges from 0 to 23. Then press S10 to adjust the minute, which ranges
from 0 to 59.
Press S12 again to finish the time setting. The indicator H11 goes off. The nixie tube
displays the hour and minute.
For the diagrams, see the initial configuration parameter manual for the solution in use.
You can also turn off the emergency light by pressing and holding the TEST button for more than
5s.
If the result expected for each step appears, the emergency light is working properly.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
9 Commissioning Core Components
99

Advertisement

Table of Contents
loading

Table of Contents