Commissioning The Emergency Lights (Standard) - Huawei FusionModule1000A Commissioning Manual

FusionModule1000A40 Prefabricated All-in-One Data
Center
Commissioning Guide

8.5.1.2 Commissioning the Emergency Lights (standard)

Prerequisites
The sockets of the emergency light have been powered on.
Preparations
Tools: step ladder, needle-shaped tool
Documents required: power supply and distribution system diagrams, fire extinguishing
device layout diagram (standard)
Skill requirement: fire engineer
Procedure
Step 1 When you press down the TEST button on the emergency light, the emergency light turns on.
When you release the TEST button, the emergency light turns off.
Step 2 When you unplug the power plug of the emergency light, the emergency light turns on. When
you stab the small hole shown in the figure with a needle-shaped tool, the emergency light
turns off.
Figure 8-35 Small hole in the emergency light
----End
Issue 02 (2019-12-20)
For the diagrams, see the initial configuration parameter manual for the solution in use.
 You can also turn off the emergency light by pressing and holding the TEST button for more than
5s.
 If the result expected for each step appears, the emergency light is working properly.
Copyright © Huawei Technologies Co., Ltd.
8 Commissioning Core Components
111