Komatsu Galeo PC800-8 Shop Manual page 914

SEN01054-01
23. Remove bracket (26).
24. Remove cover (27).
25. By barring the engine with bolt (BB), set stamp
(A) of the damper to pointer (P) (from the coun-
terweight side).
a At this time, the stamp of 2.5 TOP is
almost at the top.
26. Check that bolt hole (H) is set to the tap hole of
the fuel supply pump drive gear.
a If the bolt hole is not set accurately, bar
the engine one more turn (The bolt hole is
set when the key is on the upper side).
27. Remove nut (28).
a The washer and nut (28) are set as one
unit. Take care not to drop nut (28).
28. Install tool A1.
29. Tighten bolt (B) to pull out the gear.
a Keep tool A1 installed until the gear is
installed again.
4
30. Disconnect bracket (29).
31. Remove fuel supply pump (30).
[*10]
50 Disassembly and assembly
PC800, 850-8