Komatsu Galeo PC800-8 Shop Manual page 981

50 Disassembly and assembly
4. Set tools N9 and N10 in same way as for oper-
ation to remove pin, then use tool N9 (adapter,
extension, guide, adapter, bolt) for press fitting
pin, and tool N10 (extension, guide, adapter,
bolt) for press fitting bushing, and press fit in
turn.
5. Use tool N13 (294 kN {30 ton} puller) in same
way as when disassembling, and push open
link (5) at bushing end.
6. Set link (6) at pin end to link (5) at bushing end,
connect with tool N11 (guide), then remove
tool N13 (puller).
PC800, 850-8
7. Set tool N9 at pin (7) end, then use tool N12
(adapter, bolt, and guide) to press fit pin (7).
2
Pin press-fitting hole in link:
SEN01056-01
Gasket sealant (LG-1)
7