Komatsu Galeo PC800-8 Shop Manual page 1071

50 Disassembly and assembly
Installation
Carry out installation in the reverse order to
q
removal.
[*1]
2
Inside surface of bushing when assembling
pin: Anti-friction compound (LM-P)
2
Grease after assembling pin: Grease (LM-G)
k
When aligning the position of the pin hole,
never insert your fingers in the hole.
a Adjust with shims so that clearance (a) between
bracket (4) and the end face of the foot of boom
(3) is less than 1 mm.
Shim thickness : 1.0, 1.5 mm
q
Bleeding air
q
a Bleed the air.
For details, see Testing and adjusting,
"Bleeding air from each part".
Refilling with oil (hydraulic tank)
q
a Add oil through oil filler to the specified
level. Run the engine to circulate the oil
through the system. Then check the oil
level again.
PC800, 850-8
SEN01058-00
21