Komatsu Galeo PC800-8 Shop Manual page 422

SEN00913-02
6) Function for selection of wiper specification
The wiper specification can be set.
• One wiper: Machine with standard cab
• Two wipers: Machine
(Upper wiper and lower wiper)
a If this setting is not matched to the spec-
ification of the actually installed wiper,
the wiper may not operate normally or an
error is detected.
22. Function for adjustment [07]
Applicable machines
PC800-8: 50001 – 50062, 55001 – 55045
PC850-8: 10001 – 10007, 55001 – 55045
The machine can be adjusted with the machine
monitor.
1) Selection of menu
Select "07 Adjustment" on the service menu
and press the [
2) Selection of sub menu
Select the sub menu to check the setting
and press the [
28
or fixed-front window cab
(Only upper wiper)
with fixed-front
window cab (if equipped)
] switch.
] switch.
No. Sub menu of adjustment
00 Return (Finish adjustment)
01 Pump Absorption Torque
3) Function of pump absorption torque
T h e p u m p a b s o r p t i o n t o r q u e c a n b e
adjusted in the following ranges.
a Basically, this setting does not need to
be changed.
Adjustment
Pump absorption torque
value
220 +98.1 Nm {+10.0 kgm}
221 +73.5 Nm {+7.5 kgm}
222 +49.0 Nm {+5.0 kgm}
223 +24.5 Nm {+2.5 kgm}
224
225 –24.5 Nm {–2.5 kgm}
226 –49.0 Nm {–5.0 kgm}
227 –73.5 Nm {–7.5 kgm}
228 –98.1 Nm {–10.0 kgm}
30 Testing and adjusting
0.0 Nm {0.0 kgm}
PC800, 850-8