Komatsu Galeo PC800-8 Shop Manual page 1088

SEN01059-01
a Stick both-sided adhesive tape (6b)
additionally for door lower window
glass (3).
Positions to stick additional both-
q
sided adhesive tape for door lower
window glass:
(j) : 110 mm
(k) : 90 mm
(m) : 200 mm
4) Stick both-sided adhesive tape (6) for front
window glass (4) as shown in the figure.
10
50 Disassembly and assembly
a Stick both-sided adhesive tape (6c) of
the lower side of the front window
glass along the outside edge of the
lower line, differently from other both-
sided adhesive tapes (6). (If it is
stuck along the inside, it will be seen
through the transparent part of the
glass.)
+
5. Position the new window glass.
1) Check the clearance between the window
glass and the operator's cab on the right,
left, upper, and lower sides, and then
adjust it evenly.
2) Stick tapes [6] between window glass (9)
and operator's cab (8) and draw position-
ing line (n).
a Stick tapes [6] to the right, left, and
lower parts of the right side window
glass, left side rear window glass, and
door lower window glass for accurate
positioning.
3) Cut the tape between window glass (9)
and operator's cab (8) with a knife, and
then remove the window glass.
a Do not remove the tapes left on the
window glass and operator's cab
before installing the window glass.
PC800, 850-8