Komatsu Galeo PC800-8 Shop Manual page 1084

SEN01059-01
Special tools
Part number
Lifter
1 793-498-1210
(Suction cup)
Y
2 20Y-54-13180 Adapter
Removal
a Remove the window glass to be replaced
according to the following procedure.
1. Using seal cutter [1], cut the adhesive between
broken window glass (7) and operator's cab
(metal sheet) (8).
a If a seal cutter is not available, make holes on
the adhesive and both-sided adhesive tape
with a drill and pass a fine wire (piano wire,
etc.) [2] through the holes. Grip the both ends
of the wire with priors [3], etc. (or hold them by
winding them onto something) and move the
wire to the right and left to cut the adhesive
and both-sided adhesive tape. Since the wire
may be broken by the frictional heat, apply
lubricant to it.
(The figure shows the operator's cab of a
wheel loader.)
6
Part name
t 2
t 2
50 Disassembly and assembly
a If the window glass is broken finely, it may be
removed with knife [4] and a screwdriver.
a Widening the cut with a screwdriver, cut the
adhesive and both-sided adhesive tape with
knife [4].
(The figure shows the operator's cab of a
wheel loader.)
2. Remove the window glass.
Installation
1. Using a knife and scraper [5], remove the
remaining adhesive and both-sided adhesive
tape from the metal sheets (glass sticking sur-
faces) of the operator's cab.
a Remove the adhesive and both-sided
adhesive tape to a degree that they will
not affect adhesion of the new adhesive.
Take care not to scratch the painted sur-
f a c e s . ( I f t h e pa i n t e d s u r f a c e s a r e
scratched, adhesion will be lowered.)
(The figure shows the operator's cab of a
wheel loader.)
PC800, 850-8