Komatsu Galeo PC800-8 Shop Manual page 960

SEN01055-01
5. No. 2 carrier assembly
Lift No. 2 carrier assembly (17) and install it.
a Adjust the positions of the 4 gear shaft
ends before installing it.
6. No. 2 sun gear
1) Set thrust washer (16).
a Be sure to set the washer before installing
No. 2 carrier assembly (17).
2) Assemble No. 2 sun gear (15) in No. 2
carrier assembly (17).
3) Install spacer (14) and button (36).
4) Install thrust washer (13).
18
50 Disassembly and assembly
7. Ring gear
Lift ring gear (12) and install it.
a Apply gasket sealant to the periphery of
the oil level check hole only.
2
Mating face of ring gear and case:
8. Assemble No. 1 carrier assembly as follows.
a There are the remains of the caulking
when the pin is inserted at the end face of
hole (h) at the side of the carrier, so
remove the caulked metal from the inside
diameter of the hole before starting to
assemble.
1) Assemble bearing (10) to gear (9), fit top
and bottom thrust washers (8) and (11)
and set gear assembly to carrier (7).
Gasket sealant (LG-6)
PC800, 850-8