Komatsu Galeo PC800-8 Shop Manual page 1055

50 Disassembly and assembly
Installation
Carry out installation in the reverse order to
q
removal.
[*1]
k
When aligning the mounting position of the
pin, do not insert your fingers in the pin
hole.
[*2]
k
When aligning the mounting position of the
pin, do not insert your fingers in the pin
hole.
a Adjust with shims so that the clearance at
the cylinder bottom end is less than 1 mm.
a Bleed the air from the work equipment circuit.
For details, see Testing and adjusting, "Bleed-
ing air from hydraulic cylinder".
Refilling with oil
q
a Add oil to the specified level, and run the
engine to circulate the oil through the sys-
tem. Then check the oil level again.
PC800, 850-8
SEN01058-00
5