Komatsu Galeo PC800-8 Shop Manual page 1087

50 Disassembly and assembly
4. Stick both-sided adhesive tape (6) along the
inside edge of the glass sticking section.
a Do not remove the release tape of the
both-sided adhesive tape on the glass
sticking side before sticking the glass.
a When sticking the both-sided adhesive
tape, do not touch the cleaned surface as
long as possible.
a Take that the both-sided adhesive tape will
not float at each corner of the window
frame.
a When sticking both-sided adhesive tape
(6) around a frame, do not lap its finishing
end over the starting end but make clear-
ance (e) of about 5 mm between them.
1) Stick both-sided adhesive tape (6) for right
side window glass (1) as shown in the fig-
ure.
PC800, 850-8
a Stick both-sided adhesive tape (6a)
additionally for right side window
glass (1).
Positions to stick additional both-
q
sided adhesive tape for right side win-
dow glass:
(f) : 50 mm
(g) : 90 mm
(h) : 250 mm
2) Stick both-sided adhesive tape (6) for left
side rear window glass (2) as shown in the
figure.
3) Stick both-sided adhesive tape (6) for door
lower window glass (3) as shown in the
figure.
SEN01059-01
9