Komatsu Galeo PC800-8 Shop Manual page 966

SEN01055-01
13. No. 1 carrier assembly
1) Using eyebolts [6], remove No. 1 carrier
assembly (32).
2) Disassemble No. 1 carrier assembly as
follows.
i) Knock pin (33) into shaft (34).
ii) Remove shaft (34) from pin end.
a Remove the pin from the shaft.
iii) Pull out gear (35) from carrier (36),
then remove thrust washer (37) and
bearing (38).
24
50 Disassembly and assembly
14. No. 1 ring gear
Remove No. 1 ring gear (39).
15. No. 1 sun gear
Remove No. 1 sun gear (40).
16. Thrust washer
Remove thrust washer (48) from travel motor.
17. Floating seal
Remove floating seal (17).
a If the seal is to be used again, be careful
not to damage the contact surface, and
keep in a safe place.
18. Travel motor assembly
Turn over shaft (41), and using eyebolts [7],
remove travel motor assembly (42).
PC800, 850-8