Komatsu Galeo PC800-8 Shop Manual page 1095

50 Disassembly and assembly
3. Raise the front window assembly and fix it with
the rear locks (on both sides).
a Check that the locks in the rear of the
operator's cab are applied securely.
4. Install left corner block (1).
a Tighten striker bolt (2) permanently after
adjusting it in step 5 below.
a Install the left corner block so that there
will be no level difference at rolling surface
(R) of the roller.
a Install left corner block (1) so that level dif-
ference (a) between it and the rail will be 0
– 1.0 mm.
PC800, 850-8
5. Adjust the striker bolt (Adjust the "close" lock
side of the front window assembly) according
to the following procedure.
1) Tighten left striker bolt (2) and right striker
bolt (3) at roughly right positions so that
cab-side trim seal (18) will be fitted to front
window glass (19).
2) Open and close the front window assem-
bly and check the working condition of
right and left locks (20).
1] If both locks do not work normally,
move the striker bolts toward the rear
of the cab and tighten them again.
2] After moving the striker bolts, check
the fitness of front window glass (19)
and cab-side trim seal (18) which was
checked in step 1).
3] Repeat the work in 1] and 2] until the
fitness of the front window glass and
the working condition of both locks
(20) are acceptable, and then tighten
the striker bolts.
6. After adjusting the striker bolts, splash water
heavily over the front window glass and check
that the water does not leak into the cab.
SEN01059-01
17