Komatsu Galeo PC800-8 Shop Manual page 1097

50 Disassembly and assembly
9) Adjusting right and left rubber stop-
pers (22)
1] Bring right and left rubber stoppers
(22) in contact with front window
assembly (13) (while it is "open").
2] Close front window assembly (13).
3] Rotate right and left rubber stoppers
(22) to the left by 1.5 turns.
a Rotating rubber stoppers (22) to
the left by 1 turn is equivalent to
compressing the rubber about
1.5 mm.
a While the front window assem-
bly is "open", it must compress
right and left rubber stoppers
(22) by 1.5 – 3.0 mm.
4] Tighten locknuts (26) of right and left
rubber stoppers (22).
8. Adjust front window assembly stopper (28).
1) Adjust and fix right and left stoppers (28)
so that stoppers (D) of front window
assembly (13) will be in contact with faces
(c) of stoppers (28) when front window
assembly (13) is pulled up.
PC800, 850-8
9. Check the latching effort of the front window
assembly.
1) After finishing steps 5 – 8, check that
latching efforts of right and left locks (20)
and (21) are even.
a Check the latching efforts on both
"close" side (at the front of the opera-
tor's cab) and "open" side (at the rear
of the operator's cab).
[*2]
3
Left lower pin:
27 – 34 Nm {2.75 – 3.47 kgm}
2
Mounting bolt: Adhesive (LT-2)
SEN01059-01
19