Komatsu Galeo PC800-8 Shop Manual page 1090

SEN01059-01
5) Apply adhesive (15) to the outside of both-
sided adhesive tape (6) of the operator's
cab.
a Apply adhesive (15) to dimensions (s)
and (t) of both-sided adhesive tape
(6) of operator's cab (8).
Dimension (s): 10 mm
q
Dimension (t): 15 mm
q
a Apply adhesive (15) higher than both-
sided adhesive tape (6).
a Apply the adhesive evenly.
a Apply adhesive (15) additionally for
additional both-sided adhesive tape
(6a) of the right side window glass
and additional both-sided adhesive
tape (6b) of door lower window glass.
12
50 Disassembly and assembly
7. Install the window glass.
1) Install window glass (9), matching it to the
lines of the positioning tapes drawn in step
5.
a Since the window glass cannot be
removed and stuck again, stick it very
carefully.
a Stick the glass within 5 minutes after
applying the adhesive.
2) After sticking window glass (9), press all
around it until it is stuck to the both-sided
adhesive tape.
a Press the corners of the window glass
firmly.
a You can perform this work efficiently
by pulling window glass (9) from
inside of the operator's cab with suc-
tion cup Y1.
PC800, 850-8