Komatsu Galeo PC800-8 Shop Manual page 420

SEN00913-02
20. Function for recording phone No. [05]
In the display of action code, a telephone num-
ber and failure code are shown alternately.
Phone number can be inputted or modified in
the following manner.
a If there is no Phone number registered, the
display for Phone numbers does not appear.
1) Selection of menu
Select 05 Phone Number Entry menu in the
display of Service Menu, and depress [
switch.
2) Changing the display
Select Entry next to change the display to
the Phone Number Entry display.
a Even if a Phone number is already input-
ted, it is deleted, upon switching to the
Phone Number Entry display.
3) Entry and setting Phone number
Following the method explained below,
Entry a Phone number in the Phone Num-
ber Entry display. (Entry automatically
begins with a cursor at the left end)
i) Enter a number into a cursor at the left
end with a ten-key.
ii) Depress [
bers have been entered.
a Numbers can be entered up to the max.
12 digits, but omit unnecessary digits.
26
] switch when all the num-
a When entering a wrong number, de-
press [Swing priority] switch, then the
cursor goes back by one digit.
a When input is finished, the display
changes to Entry display shown above.
If the inputted Phone number is shown in
this display, the input is normal.
]
21. Function for initial value setting and default [06]
It is possible to change the following settings for
the machine monitor as well as the machine.
Make a change as is required.
• Working mode when the engine starting
switch is in the ON position.
• Display language in Service Menu
• Display unit in the monitoring function
• Setting of double wiper or single wiper
1) Selection of menu
Select 06 "AAAA/Default menu" in the ini-
tial display of Service Menu, and depress
[ ] switch.
30 Testing and adjusting
PC800, 850-8