Trip Circuit Supervision Tcshscbr/Tcslscbr - ABB Remote I/O RIO600 Installation And Commissioning Manual

1MRS757488 H
Parameter name Range
Pulse length
Signal type
Output Channel 1
Enabled
Output Channel 2
Enabled
Output Channel 3
Enabled
Output Channel 4
Enabled
Output Channel 1
Inversion
Output Channel 2
Inversion
Output Channel 3
Inversion
Output Channel 4
Inversion
6.1.8.4
RIO600
Installation and Commissioning Manual
Unit
10 to 65535 ms
Static/Pulse
Enabled/Disabled
Enabled/Disabled
Enabled/Disabled
Enabled/Disabled
Non-inverted/inverted
Non-inverted/inverted
Non-inverted/inverted
Non-inverted/inverted

Trip circuit supervision TCSHSCBR/TCSLSCBR

Identification
Description
Trip circuit supervision
Functionality
The trip circuit supervision function TCSHSCBR/TCSLSCBR supervises the control
circuit of the circuit breaker. The invalidity of a control circuit is detected by using a
dedicated input (Input 4) contact. The failure of a circuit is reported to the
corresponding function block in the IED configuration.
The operating time characteristic is according to the definite time (DT). The function
activate alarm after a predefined operating time and resets when the fault disappears.
Operation principle
The Operation setting is used to enable or disable the function. The corresponding
parameter values are "On" and "Off".
The operation of TCSLSCBR can be described by using a module diagram. All
modules in the diagram are explained in the next sections.
Default value
10
Static
Enabled
Enabled
Enabled
Enabled
Non-inverted
Non-inverted
Non-inverted
Non-inverted
IEC 61850 IEC 60617
identification identification
TCSHSCBR/ TCS
TCSLSCBR
Section 6
Commissioning
Description
The integer value in this
parameter indicates the
pulse length for the
output channels in ms.
Output signal type: static/
pulse
Output channel 1:
enabled/disabled
Output channel 2:
enabled/disabled
Output channel 3:
enabled/disabled
Output channel 4:
enabled/disabled
Output channel 1: non-
inverted/inverted
Output channel 2: non-
inverted/inverted
Output channel 3: non-
inverted/inverted
Output channel 4: non-
inverted/inverted
ANSI/IEEE C37.2
device number
TCM
165