ABB Remote I/O RIO600 Installation And Commissioning Manual page 52

Section 5
Installing
44
voltage sensor based on capacitive divider principle. The sensor is equipped with
current and voltage signal cable with RJ-45 connector for connection with SIM8F
module. There are also separate current and voltage sensors which are wired to a
single RJ-45 connector with adapter.
• Use the cable connector type RJ-45 for connecting the sensors with SIM8F.
• Connect both current and voltage signals to the sensor input for proper operation.
Preferred ABB combined sensor for RIO600 is KEVCY 24 RE1, KEVCY 36 RE1,
KEVCY 40.5 RE1 or KEVCD A.
Preferred combination of ABB current sensors is KECA 80 C85 and ABB voltage
sensor KEVA 24 C10, 24 C21, 24 C22, 24 C23, 17.5 B20, 17.5 B21, 24 B20, or 24
B21.
RIO600 supports also split-core current sensor type for retro-fit purposes. Preferred
split-core sensor is KECA 80 D85.
KEVCY XX RE1
GUID-D2C381D7-7B48-49CA-8677-35DC27DBB38E V1 EN
Figure 23: Connecting combisensor to RIO600 RJ-45
Cable RJ-45
I+U
1MRS757488 H
RIO600
RJ-45
Installation and Commissioning Manual
RIO600