Operating Parameter Settings Of Aom4 - ABB Remote I/O RIO600 Installation And Commissioning Manual

1MRS757488 H
6.1.5
Table 27:

Operating parameter settings of AOM4

Parameter name Range
Description
Output Mode
Output Max
Output Min
Value Unit
Value Max
Value Min
Deadband Value
RIO600
Installation and Commissioning Manual
Otherwise, the last reported measurement value is continued to be made available for
the application.
Deadband formula:
[ABS (new value – last reported value) > (% of Deadband value × Measured range)]
The measured range is the difference between the parameters Input Max value and
Input Min value.
Measured range = ABS (Input Max – Input Min)
For example, if Input Min = 0, Input Max = 20, Deadband value = 1% and Last
reported value = 10 and if the new measured value is less than 9.8 or greater than 10.2,
the measured value should be reported.
If the value remains unchanged, it is reported after every 30 seconds.
Since the functionality can be utilized in various measurement modes,
the default values are set to minimum. Thus, it is very important to set
correct limit values to suit the application before the deadband
supervision works properly.
Operating parameter settings of AOM4
Unit
0...20 mA
Not in use
0...20
0...20
Dimensionless
mA
Dimensionless:
-100000.0...+100000.0
mA: 0...20
Dimensionless:
-100000.0...+100000.0
mA: 0...20
0...10 %
Default value Description
Analog Output User-defined channel name not exceeding 30
1...4 characters
Not in use Mode of configuration
When "Not in use" is selected, the channel is
disabled.
20 Maximum value of mA output
0 Minimum value of mA output
Dimensionless Value unit depends on the configuration type.
20.0 Upper limit of the range for GOOSE
For Modbus the range is -32768...+32768
0.0 Lower limit of the range for GOOSE
For Modbus the range is -32768...+32768
0 Deadband value in percentage
Deadband not applicable when set to 0
Section 6
Commissioning
67