ABB Remote I/O RIO600 Installation And Commissioning Manual page 273

1MRS757488 H
RIO600
Installation and Commissioning Manual
• If the time sync source is disabled or not configured, the status is "-".
• If the time sync source is configured as SNTP and if the server is accessible
to RIO600, the time sync status is "Good". Otherwise the status is "Bad".
• If the time sync source is configured as Modbus and RIO600 receives the
time synch information from the MODBUS master, the time sync status is
"Good". Otherwise the status is "Bad".
Select the Configuration view in the menu bar to access the
configured SNTP server 1 and 2 addresses.
• View I/O Status to see the LED statuses of the channels of the binary I/O
modules.
• Grey indicates that the LED is off
• Yellow color indicates that the LED is on
The LED status does not reflect the actual output if the DOM
output is configured as pulse mode or when SCM8H/SCM8L
module is configured for application types other than 4 I/O.
In case of SIM8F and SIM4F, click the Click Here link to see the detailed status.
GUID-E5D6E906-2853-4033-AB77-D51C0F54E69F V4 EN
Figure 95: SIM8F status
The direction information for multi-frequency admittance-based
earth-fault indication is according to the Start & Operate
indication.
Section 8
Using the Web HMI
265