ABB Remote I/O RIO600 Installation And Commissioning Manual page 296

Section 10
Technical data
288
Table 195: Sensor input module (SIM8F)
Description
Preferred ABB sensors
Current measurement Range
Accuracy
Line voltage Range
measurement
Accuracy
Power measurements: Range
P, Q, S and PF
Accuracy
Line frequency Range
measurement
Accuracy
Average operating current, voltage and power
Peak current, voltage and power values
General detection of the harmonics disturbances
Load flow direction
Non-directional Operating range
overcurrent fault
Accuracy
detection
Directional overcurrent Operating range
fault detection
Accuracy
Table continues on next page
Value
• Combined sensors KEVCY 24 RE1,
KEVCY36 RE1, KEVCY 40.5 RE1, KEVCD
A
• Combination of current sensor KECA 80
C85 or KECA D85 and voltage sensor KEVA
24 C10, 24 C21, 24 C22, 24 C23, 17.5 B20,
17.5 B21, 24 B20, or 24 B21
4...8000 A
±5% or ±1 A in the range of 4...80 A
±1% in the range of 80...4800 A
±10% in the range of 4800...8000 A
480 V...48 kV
±5% in the range of 480...9600 V
±0.5% in the range of 9.6...48 kV
9.6...28.8 kV
80...630 A
±1.0% for active power P (±0.5% at +25⁰C)
±3.0% for reactive Q and apparent power S (±1%
at +25⁰C)
±0.03 for power factor
±3.0% for energy
50 or 60 Hz
For 50 Hz, ±50 mHz
For 60 Hz, ±60 mHz
Average operating current, voltage, power
according to selection: 3 min/10 min/15 min/1
hour/2 hours/24 hours
Peak values for 1 day, 1 week, 1 month, 1 year
• Current TDD (Total demand distortion) up to
the 8th harmonics
• Voltage THD (Total harmonic distortion) up
to the 8th harmonics
Forward/reverse
50...2000 A
Depending on the nominal frequency of the
current measured: f
n
±1.5% of the set value
Operate time: ±1.0% of the set value or ±20 ms
50...2000 A
Depending on the nominal frequency of the
current measured: f
n
Current: ±1.5% of the set value
Voltage: ±1.5% of the set value
Phase angle: ±2⁰
Operate time: ±1.0% of the set value or ±20 ms
Installation and Commissioning Manual
1MRS757488 H
RIO600