Delta AH Series Operation Manual page 173


eCamCurve
0: leftCAM
2: midCAMbegin
5: right CAM
8: midCAMend







Example
The parameters of creating a rotary cut curve by means of the motion control function block DFB_CamCurve2 are
described below.
Distance for which the master axis specified moves=1000
Distance for which the slave axis specified moves=500
Distance for which the slave axis specified is synchronized with the master axis specified=300
Synchronization ratio of the speed of the slave axis specified to the speed of the master axis specified=1.0
The rotary cut curve created and the values of parameters are shown below.
Ch ap te r 7 M oti on Co n tro l Prog ram m ing
1: midCAMall
3: midCAMend
7: midCAMbegin
9: Empty
7_
7 - 4 7