Table of Contents
Advertisement
Values for the following settings are saved in input presets:
• Preset name
• Film mode detection
• Contrast
• Brightness
• Detail
Saving a preset when using a matrix switcher
When using the DTP2 CrossPoint 82 with a matrix switcher, do the following to save a preset:
1. Switch each input of the matrix to the DTP2 CrossPoint 82.
2. Configure each input: size, position, detail, brightness, and contrast.
3. Save the settings to a preset for recall by the control system when that matrix input is routed to any DTP2
CrossPoint 82 input.
Tie Presets
A matrix tie preset is a complete map of all input, logo, and output tie connections that are saved and stored in
global memory slots. Up to 16 presets can be saved to any of the available memory addresses.
Power Save Modes
The DTP2 CrossPoint 82 can be placed into a standby (low power) mode via SIS commands (see the
Save
commands on page 70) in order to conserve power. To restore the unit to full power mode, enter the
appropriate SIS command, press any front panel button, switch inputs via SIS command, or cycle power to the
unit. The following power save modes are supported:
•
Mode 0 — Full power mode
•
Mode 1 — All non-essential hardware is shut down.
•
Mode 2 — All non-essential hardware is shut down, but over-TP functionality and remote power remain
enabled.
Reset Modes
The DTP2 CrossPoint 82 switchers have three reset modes. Use a small screwdriver or stylus to press
and hold the recessed Reset button to advance through the modes. The green Reset LED blinks to
indicate each mode that is enabled (see the
NOTE: This Reset button and LED are located in the lower-right corner of the rear panel, and are unrelated
to the Reset button and LED in the IPCP control panel of the DTP2 CrossPoint 82 IPCP models.
You can also perform resets using the OSD (see
Resets commands
commands for
ATTENTION:
•
Review the reset modes carefully. Using the wrong reset mode may result in unintended loss of flash
memory programming, port reassignment, or unit reboot.
•
Étudier de près les différents modes de réinitialisation. Appliquer le mauvais mode de réinitialisation
peut causer une perte inattendue de la programmation de la mémoire flash, une reconfiguration des
ports ou une réinitialisation du processeur.
NOTE: The reset modes listed close all open IP and Telnet connections and all sockets. Each mode is a
separate function, not a continuation.
• Horizontal image position
• Vertical image position
• Horizontal image size (width)
• Vertical image size (height)
Reset Mode Summary
Factory Reset
on page 66), and PCS (see the DTP2 CrossPoint 82 PCS Help file).
DTP2 CrossPoint 82 Scaling Presentation Matrix Switchers • Operation
table on the next page).
on page 39), SIS commands (see the
Power
RESET
RESET
42
Advertisement
Table of Contents
