Omron C200HX Operation Manual page 510

Host Link Commands
10-3-28 MULTIPLE FORCED SET/RESET –– FK
Command Format
1 0
x 10 x 10
@ F
Node no. Header
code
Response Format
492
Force sets, force resets, or cancels the forced status of the bits in one word in the
IR, SR, LR, HR, or AR, or a timer/counter Completion Flag.
OP1 OP2 OP3 OP4 x 10
K
Operand
Bit 15 14
For data areas IR, SR, LR, HR, and AR, the "Operand" parameter indicates the
data area where the bit will be force-set and the "Word address" parameter indi-
cates the word address.
For the TC area, "Operand" parameter indicates the mnemonic of the timer or
counter instruction and the "Word address" parameter indicates the TC number.
Data area/
i instruction t ti
IR or SR
LR
HR
AR
TIMER
HIGH-SPEED TIMER
COUNTER
REVERS. COUNTER
TOTALIZING TIMER
TRANSITION FLAGS
The 16 bytes of forced set/reset/cancel data specifies what operation will be per-
formed on the specified data area word or Completion Flag. If a timer or counter
is specified, the status of the Completion Flag is force-set or force-reset using
the setting for bit 15, and the settings for bits 00 through 14 will be ignored. Only
force-setting and force-resetting are possible for timers/counters.
Forced set/reset/cancel data
0000
0010
0011
0100
0101
1000
x 10
@
Node no.
3 2 1 0
x 10 x 10 x 10
Word
address
Forced set/reset/cancel data
13 12 11 10
Operand
OP1 OP2 OP3
C I O
L R (Space) (Space) 0000 to 0063
H R (Space) (Space) 0000 to 0099
A R (Space) (Space) 0000 to 0027
T I M
T I M
C N T
C N T
T T I
T N (Space) (Space) 0000 to 1023
Bit status not changed
Reset to 0.
Set to 1.
Forced-reset
Forced-set
Cancel forced set/reset status
1 0 1
x 10 x 16 x 16
F K
Header End code
code
Section 10-3

FCS Terminator
1 0
Word
address dd
OP4
(Space) 0000 to 0511 00 to 15
(Space) 0000 to 0511 Always
00 00
H
(Space)
R
M
Operation
 ↵
0
FCS Terminator
↵
Bit
y