Omron C200HX Operation Manual page 503

Host Link Commands
Response Format
Limitations
PC Settings
Execution Conditions
End Codes
10-3-23 STATUS READ –– MS
Command Format
Response Format
1 0
x 10 x 10
@
Node no.
x 10
@
Node no.
The command is valid only when the UM setting is ladder only.
SR 253 through SR 255 can't be specified.
The command can't be executed if the UM area is write-protected.
PC Mode
RUN MONITOR
--- OK
Commands
Single
OK
An end code of 14 (format error) will be returned if the length of the command is
incorrect.
An end code of 15 (entry number data error) will be returned if the program ad-
dress isn't BCD, the program address exceeds the maximum address in the pro-
gram, the mnemonic/TC number is incorrect, or the SV is incorrect.
An end code of 16 (command not supported) will be returned if the specified
instruction doesn't exist in the program.
End code
00 Normal completion
01 Not executable in RUN mode
04 Address over
13 FCS error
14 Format error
15 Entry number data error
16 Command not supported
18 Frame length error
23 User memory protected
Reads the PC operating conditions.
@
1 0 3
x 16 x 16 x 16 x 16
M S
Header End code Status data
code
1 0 1
x 10 x 16 x 16
W %
Header End code
code
PROGRAM Write-protected
OK
Multiple
---
Contents
1 0
x 10 x 10
M S
Node no. Header
code
2 1 0
x 16 x 16 16 characters
Message
Section 10-3
0
 ↵
FCS Terminator
UM Area
Read-protected
--- OK
Responses
Single Multiple
OK ---
 ↵
FCS Terminator
 ↵
FCS Terminator
485