Omron C200HX Operation Manual page 507

Host Link Commands
Limitations
PC Settings
Execution Conditions
End Codes
10-3-26 FORCED SET –– KS
Command Format
1 0
x 10 x 10
@ K
Node no. Header
code
When errors are being cleared (error clear = 01), the errors are read after the
error clear function is executed.
PC Mode
RUN MONITOR
OK OK
Commands
Single
OK
An end code of 14 (format error) will be returned if the length of the command is
incorrect.
An end code of 15 (entry number data error) will be returned if the error clear
parameter isn't set to 00 or 01.
End code
00 Normal completion
13 FCS error
14 Format error
15 Entry number data error
18 Frame length error
Force sets an IR, SR, LR, HR, or AR bit or the Completion Flag of a timer or
counter. Once a bit has been forced set or reset, that status will be retained until
FORCED SET/RESET CANCEL (KC) is transmitted.
OP1 OP2 OP3 OP4 x 10
S
Operand
For data areas IR, SR, LR, HR, and AR, the "Operand" parameter indicates the
data area where the bit will be force-set and the "Word address" parameter indi-
cates the word address.
For the TC area, "Operand" parameter indicates the mnemonic of the timer or
counter instruction and the "Word address" parameter indicates the TC number.
Data area/
instruction i i
IR or SR
LR
HR
AR
TIMER
HIGH-SPEED TIMER
COUNTER
REVERS. COUNTER
TOTALIZING TIMER
TRANSITION FLAGS
PROGRAM Write-protected
OK OK
Multiple Single
--- OK
Contents
3 2 1 0 1
x 10 x 10 x 10 x 10 x 10
Word Bit
address
Operand
OP1 OP2 OP3 OP4
C I O (Space) 0000 to 0511
L R (Space) (Space) 0000 to 0063
H R (Space) (Space) 0000 to 0099
A R (Space) (Space) 0000 to 0027
T I M (Space) 0000 to 0511
T I M H
C N T (Space)
C N T R
T T I M
T N (Space) (Space) 0000 to 1023
Section 10-3
UM Area
Read-protected
OK
Responses
Multiple
---
 ↵
0
FCS Terminator
Word Bit
address dd
00 to 15
Always y
00 00
489