Omron C200HX Operation Manual page 341

Network Instructions
SYSMAC NET Link Systems
SYSMAC LINK Systems
The destination port number is always set to 0. Set the destination node number
to 0 to send the data to all nodes. Set the network number to 0 to send data to a
node on the same Subsystem (i.e., network). Refer to the SYSMAC NET Link
System Manual for details.
Word Bits 00 to 07
C Number of words (0 to 1000 in 4-digit hexadecimal, i.e., 0000
C+1 Network number (0 to 127 in 2-digit
hexadecimal, i.e., 00
C+2 Destination node (0 to 126 in 2-digit
hexadecimal, i.e., 00
*The node number of the PC executing the send may be set.
Set the destination node number to 0 to send the data to all nodes. Refer to the
SYSMAC LINK System Manual for details.
Word Bits 00 to 07
C Number of words (0 to 1000 in 4-digit hexadecimal, i.e., 0000
C+1 Response time limit (0.1 and 25.4
seconds in 2-digit hexadecimal
without decimal point, i.e., 00
FF )
hex
Note: The response time will be
2 seconds if the limit is set to 0
There will be no time limit if the
time limit is set to FF
C+2 Destination node (0 to 62 in 2-digit
hexadecimal, i.e., 00
*The node number of the PC executing the send cannot be set.
Bit 12 ON: Direct destination
to 7F ) beginning word
hex hex
designation
OFF: Indirect designation
Bit 14 ON: Operating level 0
OFF: Operating level 1
Bits 08 to 11, 13 and 15: Set to 0.
Destination port
to 7E )* NSB: 00
hex hex
NSU: 01/02
Bits 08 to 11:
No. of retries (0 to 15 in
to hexadecimal,
hex
i.e., 0
Bit 12 ON: Direct destination
. beginning word
hex
designation
. OFF: Indirect designation
hex
Bit 13 ON: Response not
returned.
OFF: Response returned.
Bit 14 ON: Operating level 0
OFF: Operating level 1
Bit 15: Set to 1.
Set to 0.
to 3E )*
hex hex
Section 5-26
Bits 08 to 15
to 03E8 )
hex hex
Bits 08 to 15
to 03E8
hex hex)
to F )
hex hex
323