Omron C200HX Operation Manual page 497

Host Link Commands
Limitations
PC Settings
Execution Conditions
End Codes
The "Operand" parameter indicates the data area where the SV is stored or a
constant. The "SV" parameter indicates the word address or the SV itself if it is a
constant.
Operand
OP1 OP2 OP3
C I O
L R (Space)
H R (Space)
A R (Space)
D M (Space)

D M
C O N
E M (Space)

E M
The command is valid only when the UM setting is ladder only.
The command can't be executed if the UM area is read-protected.
PC Mode
RUN MONITOR
OK OK
Commands
Single
OK
An end code of 04 (address over) will be returned if the program address is
above the highest program address but less than 65,536 (32,767 in the
C200HS).
An end code of 14 (format error) will be returned if the length of the command is
incorrect.
An end code of 15 (entry number data error) will be returned if the program ad-
dress isn't specified in BCD or the operand/SV parameters are incorrect.
An end code of 16 (command not supported) will be returned if the specified
instruction doesn't exist in the program.
End code
00 Normal completion
04 Address over
13 FCS error
14 Format error
15 Entry number data error
16 Command not supported
18 Frame length error
23 User memory protected
Classification
OP4
(Space) IR or SR
(Space) LR
(Space) HR
(Space) AR
(Space) DM
(Space) DM (indirect)
(Space) Constant
(Space) EM
(Space) EM (indirect)
PROGRAM Write-protected
OK OK
Multiple Single
--- OK
Contents
Section 10-3
Constant or
word address d dd
0000 to 0511
0000 to 0063
0000 to 0099
0000 to 0027
0000 to 6655
0000 to 6655
0000 to 9999
0000 to 6143
0000 to 6143
UM Area
Read-protected
---
Responses
Multiple
---
479