Omron C200HX Operation Manual page 508

Host Link Commands
Response Format
Limitations
PC Settings
Execution Conditions
End Codes
10-3-27 FORCED RESET –– KR
Command Format
1 0
x 10 x 10
@ K
Node no. Header
code
490
1
x 10
@
Node no.
Bits in SR 253 through SR 255 can't be specified.
PC Mode
RUN MONITOR
--- OK
Commands
Single
OK
An end code of 14 (format error) will be returned if the length of the command is
incorrect.
An end code of 15 (entry number data error) will be returned if the operand, word
address, or bit parameter setting is incorrect.
End code
00 Normal completion
01 Not executable in RUN mode
13 FCS error
14 Format error
15 Entry number data error
18 Frame length error
Force resets an IR, SR, LR, HR, or AR bit or the Completion Flag of a timer or
counter. Once a bit has been forced set or reset, that status will be retained until
FORCED SET/RESET CANCEL (KC) is transmitted.
x 10
R OP1 OP2 OP3 OP4
Operand
For data areas IR, SR, LR, HR, and AR, the "Operand" parameter indicates the
data area where the bit will be force-set and the "Word address" parameter indi-
cates the word address.
0 1 0
x 10 x 16 x 16
K S
Header End code
code
PROGRAM Write-protected
OK
Multiple Single
---
Contents
3 2 1 0 1
x 10 x 10 x 10 x 10
Word Bit
address
Section 10-3
 ↵
FCS Terminator
UM Area
Read-protected
OK OK
Responses
Multiple
OK ---
 ↵
0
x 10
FCS Terminator