Omron C200HX Operation Manual page 152

Analog Timer Unit Programming
Ladder Program
1, 2, 3...
00005 Timer 0 Completion Flag
00002
00208
Timer 0 Completion Flag
00003
00209
Timer 1 Completion Flag
00004
00210
Timer 2 Completion Flag
00211
Timer 3 Completion Flag
134
The following diagram shows the example ladder program.
1. Output IR 00500 will go ON about 0.6 s (T0) after input IR 00002 goes ON.
2. Output IR 00501 will go ON about 3 s (T1) after input IR 00003 goes ON.
3. Output IR 00502 will go ON about 20 s (T2) after input IR 00004 goes ON
and IR 00503 will go ON about 8 minutes (T3) after input IR 00004 goes ON.
4. Timers 2 and 3 are stopped by input IR 00005.
Timer Stop Bit
Timer 0 Set Bit
Timer 1 Set Bit
Timer 2 Set Bit
00206 T2
Timers 2 and 3 stop operating when the
emergency stop input goes ON.
00207
T3
Timer 0 (00200) starts operating and the
T0
00200
Unit's SET indicator lights when IR 00002
goes ON.
When the time set on the internal volume
control elapses, the Completion Flag (00208)
00500 goes ON and the Unit's TIME UP indicator
lights. Output IR 00500 goes ON at the same
time.
Timer 1 (00201) starts operating and the
T1
00201
Unit's SET indicator lights when IR 00003
goes ON.
When the time set on the internal variable
resistor control elapses, the Completion Flag
00501
(00209) goes ON and the Unit's TIME UP
indicator lights. Output IR 00501 goes ON at
the same time.
00202 T2
Timer 2 (00202) and timer 3 (00203) start
operating and the Unit's SET indicator lights
when IR 00004 goes ON.
T3
00203
When the time set on the external variable
resistor control elapses, the Completion Flag
(00210) goes ON and the Unit's TIME UP
indicator lights. Output IR 00502 goes ON at
00502
the same time.
When the time set on the external variable
resistor control elapses, the Completion Flag
(00211) goes ON and the Unit's TIME UP
00503
indicator lights. Output IR 00503 goes ON at
the same time.
Section 4-13