Omron C200HX Operation Manual page 509

Host Link Commands
Response Format
Limitations
PC Settings
Execution Conditions
End Codes
For the TC area, "Operand" parameter indicates the mnemonic of the timer or
counter instruction and the "Word address" parameter indicates the TC number.
Data area/
instruction i i
OP1
IR or SR C
LR L
HR H
AR A
TIMER T
HIGH-SPEED TIMER T
COUNTER C
REVERS. COUNTER C
TOTALIZING TIMER T
TRANSITION FLAGS T
1
x 10 x 10
@
Node no.
Bits in SR 253 through SR 255 can't be specified.
PC Mode
RUN MONITOR
--- OK
Commands
Single
OK
An end code of 14 (format error) will be returned if the length of the command is
incorrect.
An end code of 15 (entry number data error) will be returned if the operand, word
address, or bit parameter setting is incorrect.
End code
00 Normal completion
01 Not executable in RUN mode
13 FCS error
14 Format error
15 Entry number data error
18 Frame length error
Operand
OP2 OP3 OP4
I O (Space) 0000 to 0511
R (Space) (Space) 0000 to 0063
R (Space) (Space) 0000 to 0099
R (Space) (Space) 0000 to 0027
I M (Space) 0000 to 0511
I M H
N T (Space)
N T R
T I M
N (Space) (Space) 0000 to 1023
0 1 0
x 16 x 16
K R
Header End code
code
PROGRAM Write-protected
OK OK
Multiple Single
--- OK
Contents
Section 10-3
Word Bit
address dd
00 to 15
Always y
00 00
 ↵
FCS Terminator
UM Area
Read-protected
OK
Responses
Multiple
---
491