Omron C200HX Operation Manual page 495

Host Link Commands
10-3-17 SV READ 1 –– R#
Command Format
1
x 10 x 10
@
Node no.
Response Format
x 10
@
Node no.
Limitations
PC Settings
An end code of 15 (entry number data error) will be returned if the specified write
data exceeds the data area boundary, the beginning word isn't specified in BCD,
or the write data isn't hexadecimal. (An end code of A5 will be returned instead of
15 for non-hexadecimal write data in multiple command frames.)
End code
00 Normal completion
01 Not executable in RUN mode
13 FCS error
14 Format error
15 Entry number data error
18 Frame length error
A3 Aborted due to FCS error in transmit data
A4 Aborted due to format error in transmit data
A5 Aborted due to entry number data error in transmit data
A8 Aborted due to frame length error in transmit data
Searches for the first instance of a TIM, TIMH(15), CNT, CNTR(12), or TTIM(87)
instruction with the specified TC number in the user's program and reads the PV,
which assumed to be set as a constant. The SV that is read is a 4-digit decimal
number (BCD).
0 1 2
OP OP OP
R #
Header Mnemonic
code
Use all four characters to specify the timer or counter instruction's mnemonic.
Add a space to the end of a TIM or CNT mnemonic to make it 4 characters long.
Instruction name
TIMER
HIGH-SPEED TIMER
COUNTER
REVERSIBLE COUNTER
TOTALIZING TIMER
1 0 1
x 10 x 16 x 16
R #
Header End code
code
The second word of the instruction must be a BCD constant from 0000 to 0511.
If the same instruction is used more than once in a program, the SV of the first
one will be read.
The command can't be executed if the UM area is read-protected.
PC Mode
RUN MONITOR
OK
Contents
3 4 3 2 1
OP x 10 x 10 x 10 x 10
TC number
(0000 to 0511)
Mnemonic
OP1 OP2
T I
T I
C N
C N
T T
0 3 2 1 0
x 10 x 10 x 10 x 10
SV
PROGRAM Write-protected
OK OK
Section 10-3
0
 ↵
Terminator
FCS
TC number
range
OP3 OP4
(Space) 0000 to 0511
M
M H
T (Space)
T R
I M
 ↵
FCS Terminator
UM Area
Read-protected
OK ---
477